Torque Support

Torque Support

Special tools, testers and auxiliary items required

• Drip tray for workshop crane (VAS 6208)

Removing

- Drain coolant => [ Cooling System, Draining and Filling ] Cooling System, Draining and Filling.

- Remove bolts - arrows - for torque support.





- Place drip tray for workshop crane (VAS 6208) under engine.





- Remove bolts - arrows -.

- Remove front coolant pipe from engine and from coolant pump.

- Remove torque support.

Installing

• Tightening Specifications => [ Coolant Pipes Assembly Overview ] Coolant Pipes Assembly Overview.

Installation is in reverse order of removal, note the following:

• Replace bolts which have been tightened to torque.

• Replace O-rings.

- Bring torque support into installation position.

- Install front coolant pipe => [ Front Coolant Line ] Front Coolant Line.

- Position torque support stop so that rubber buffer contacts top and bottom without play and tightening bolts - arrows -.





- Fill with coolant => [ Filling ] Cooling System, Draining and Filling.