Control Valve Control Unit (J808)

Control Valve Control Unit (J808)

Removing

- Remove the rear engine cover - 2 - upward.






- Disconnect the connector - 3 - from the control valve control unit.






- Remove the bolts - 5 - and - 6 -.

- Remove the bypass connection - 1 - with the adapter - 2 - and control valve control unit - 4 -.

Installing

Installation is performed in reverse order of removal, noting the following:

• Replace O-rings.

- Install the bypass connection - 1 - with the adapter - 2 - and control valve control unit - 4 -. Use new O-rings.






- Install the bolts - 5 - and - 6 - hand-tight.

- First tighten the bolts - 6 - to the tightening specification.

• Tightening specifications: 10 Nm

- Then tighten the bolts - 5 - to the same tightening specification.

- Connect the connector - 3 -.

- Perform an "Adaptation" in "Guided Functions" after replacing the control valve control module.