Removal and Replacement
Central Locking
Component Overview, Sedan
1 Right front door control module (J387)
• Integrated in window regulator.
2 Right Rear Door Control Module (J389)
• Integrated in window regulator.
3 Fuel filler door unlock motor (V155)
• Removal:
4 Comfort system central control module (J393)
• Component location, in right rear side panel, refer to => [ Comfort System Central Control Module ] Service and Repair.
5 Motor for rear lid release (V139)
6 Left Rear Door Control Module (J388)
• Integrated in window regulator.
7 Driver door control module (J386)
• Integrated in window regulator.
8 Hood switch (F266)
• Component location in lock carrier
Component Overview, Avant
1 Front passenger door control module (J387)
2 Right Rear Door Control Module (J389)
3 Fuel filler door unlock motor (V155)
• Removal:
4 Comfort system central control module (J393)
• Component location, in right rear side panel.
• Removing and installing, refer to => [ Comfort System Central Control Module ] Service and Repair
5 Vehicle positioning system interface control module (J843)
• Component location, in right rear side panel.
• Removing:
6 Motor for rear lid release (V139)
7 Rear Lid Control Module (J605)
8 Left Rear Window Shade Control Module (J765)
9 Left Rear Door Control Module (J388)
10 Driver door control module (J386)
11 Hood switch (F266)
• Component location in lock carrier
Removing the vehicle positioning system interface control module (J843)
Front Door Control Module Installation Position
- To install, insert door control module - 1 -in lower mounting points, swing upward and engage.
- Window regulator motor- 2 -.
Rear Door Control Module Installation Position
- To install, insert door control module - 1 -in lower mounting points, swing upward and engage.
Removing the Fuel Tank Lid Unlock Motor V155
Special tools, testers and auxiliary items required
• Socket wrench (T10010).
1 Motor for fuel filler door release
• Side trim on right side of luggage compartment removed.
- Disconnect electrical harness connector to motor.
- Loosen bolts - arrow - turning toward right using socket wrench (T10010) and slide motor- 1 - out of oblong holes.
- Before installing new motor, you must first slide emergency release eye- 4 -over locking pin.
• For easier installation, slide an appropriate hose - 5 -from outside to inside as an assisting tool in luggage compartment.
• Place hose - 5 -on operating rod- 4 - and pull outward in tank cup.
- Slide motor into oblong holes and tighten screws to 1.5 Nm by turning to left
2 Locking clamp
3 Operating rod
4 Cable for emergency release