Seat

Seat

Special tools, testers and auxiliary items required

• torque wrench (V.A.G 1332)

• The RS6 bucket seat does not have a side airbag. Therefore, the electrical connection for the side airbag must have a terminal resistance in the wiring harness.

• The terminal resistance is a component of the wiring harness.





1 Front Seat

Removing

- Push front seat - 1 - fully upward and to the rear.

- Remove front bolts - 3 - (quantity: 2).

- Move seat forward.

- Remove the outer side trim. Refer to => [ Side Trim ] Side Trim.

- Remove the seat belt anchor. Refer to => [ Seat Belt Anchor ] Seat Belt Anchor.

- Remove rear bolts - 4 - (quantity: 2).

- Tip front seat - 1 - back.

- Disconnect electrical harness connectors. Refer to => [ Connectors, Disconnecting and Connecting ] Connectors, Disconnecting and Connecting.

- Remove seat.

Installation

To install, perform the steps used in removal in reverse order.

2 Seat Rail Covers

• Right front and left rear are identical

• Left front and right rear are identical

• Removing and installing, refer to => [ Seat Rail Covers ] Seat Rail Covers

3 Front Bolts

Quantity: 2

• 50 Nm

4 Rear bolts

Quantity: 2

• 50 Nm