Hood: Adjustments

Hood, Adjusting

Special tools, testers and auxiliary items required

• Adjustment gauge (3371)






Gap dimensions for hood






• Dimension A = 5.0 mm

• Dimension B = 4.5 mm

• Dimension C = 5.0 mm

• Dimension D = 3.0 mm

• Dimension E = 2.5 mm



Height adjustment stop buffer





• The adjusting buffers - 2 - are used to adjust the height of the hood.

• The adjusting buffer - 2 - must lightly contact the lock carrier when the hood is closed.

• The rubber buffer - 1 - also works as a strike guard.

Replacing the hood seal






- Remove the seal and clip from the hood.

Hold panel






1 Hold panel

• Installation:

- Slide the lining over the tabs on the rear edge into the holes provided on the inner panel.

- Slide the tabs on the front edge and the sides into place.

- The clips must engage audibly when pressing in.

- Press the clip in.

2 Hood

3 Clip