Roof Antenna (R216)

Roof Antenna (R216)

The roof antenna has four connections maximum.

The antenna wires are connected directly to the base of the roof antenna.

The rear headliner must be lowered in order to remove the roof antenna.

- Turn off the ignition and all electrical consumers and remove the ignition key.

Removing

- Lower the back of the headliner..

- Unlock and disconnect the connectors - 2 -, - 3 - and - 4 - from the antenna wires.






- Remove the bolt - 5 - and remove the spring.

- Remove the roof antenna from the roof.

Installing

The roof antenna is supplied pre-installed. The roof antenna, spring and screw are installed.

- Position the roof antenna on the roof and press on it until it latches.

- Tighten the preinstalled screw to the tightening specification.

- Install in reverse order of removal.

Component location overview for the tightening specification and installation instructions refer to => [ Component Location Overview ] Component Location Overview.