Procedures

Engine, Securing to Engine and Transmission Holder

Special tools, testers and auxiliary items required

• Lifting Tackle (3033)

• Engine and Transmission Holder (VAS 6095) with Bracket for V8 Engine (VAS 6095/1-6A)

• Shop Crane (VAS 6100)

• Lift Arm Ext./Workshop Hoist (VAS 6101)

• Hose Clip Pliers (VAS 6362)

Procedure

• Engine/transmission subassembly removed; engine and transmission separated, refer to => [ Engine and Transmission, Separating ] Engine and Transmission, Separating.

• Engine secured with joint support (VAS 6131/13-7).

- Disconnect the connector - 1 -.






• Place a cloth below to catch the draining hydraulic fluid.

- Disconnect the power steering hydraulic pipe - 2 -.

- Remove the bolts - 1 and 2 -.






- Free up the wire on the left coolant pipe in the center.






- Loosen the clamps - arrows -, remove the bolts - 1 and 2 - and remove the left coolant pipe in the center from the coolant hoses.

- Engage the (3033) on the engine lifting eyes and on the shop crane as shown in the illustration.






- Tension engine slightly with shop crane, do not raise.

- Remove the bolt - arrow - from the left engine mount.






- Remove the right engine mount bolt - 1 -.






• Ignore - 2 -.

- Remove (VAS 6131/13-7) from engine.






- Raise engine from engine carrier.

- Remove the bolts - arrows - and remove the left engine support.






- Remove the bolts - arrows - and remove the right engine support - 1 -.






- Secure the starter on the engine.

- Tighten the engine with the (VAS 6095/1-6A) to the (VAS 6095) to 55 Nm, as illustrated.