High Pressure Pump

High Pressure Pump

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1331)

• Tool Insert, AF 17 (V.A.G 1331/6)

• Socket Insert AF14 (V.A.G 1331/8)

Removing

• The following description represents removal and installation of left high pressure pump.

• Fuel system is under high pressure! Before opening high pressure components of the fuel injection system, pressure must be relieved to residual pressure. Refer to => [ Before Opening High Pressure Fuel Injection System ] Service and Repair.

• Then wrap a clean rag around the connection and relieve residual pressure by carefully loosening the connection.

• Observe safety precautions when disconnecting the battery.

- With ignition switched off, disconnect Battery Ground (GND) cable.

- Remove engine cover.

- Disconnect the connectors from the low fuel pressure sensor (G410) and from the fuel metering valve 2 (N402).





- Remove both fuel line union nuts.

- Remove bolts - 3 -.

• Do not change the angles of the high pressure lines.

- Carefully remove high pressure pump.

- Remove roller tappet from cylinder head.

Installing

Installation is in reverse order of removal, note the following:

• Replace O-ring.

- Insert roller tappet in cylinder head.

- To set the high pressure pump in place, lift the high pressure lines only slightly.

- Insert high pressure pump in cylinder head and tighten.

• High pressure line connections must not show any signs of damage.

• Do not change the angles of the high pressure lines.

- Hand-tighten the union nuts for the high-pressure lines.

- Make sure the high-pressure lines are seated free of stress.

- To tighten 14 mm diameter union nut on high pressure line, use (V.A.G 1331) with (V.A.G 1331/8).





- To tighten 17 mm diameter union nut on high pressure line, use (V.A.G 1331) with (V.A.G 1331/6).





• Tightening specifications, refer to => [ High Pressure Pump Assembly Overview ] High Pressure Pump Assembly Overview.

- Observe safety precautions after connecting battery.

- Connect the connectors to the low fuel pressure sensor and to the fuel metering valve 2.

• Check fuel system for leaks.