Sunroof / Moonroof: Adjustments

Front and Rear Glass Panel Height, Adjusting

• Adjust the front glass sunroof panel only on the front edge and the rear glass sunroof panel on the rear edge.

• To achieve the best possible exterior optical characteristics, make sure that the adjustment on left and right sides is performed as evenly (symmetrically) as possible.

Check the height adjustment

- Check the adjustment of the front - 1 - and rear - 2 - glass panels with a depth gauge.





• Dimension - a - : 1.5 ± 1 mm

• Dimension - b - : 1 ± 1 mm

• Dimension - c - : 1 ± 1 mm

• Adjust the front glass sunroof panel

• Adjust the rear glass sunroof panel

Adjust the front glass sunroof panel

- Remove trim, refer to => [ Glass Panel ] Glass Panel

- Remove both left and right front screws - arrows - on the glass panel - 1 -.





- Close the glass panel.

- Adjust the glass panel - 1 - according to the illustration.





• Dimension - a - : 1.5 ± 1 mm

• Dimension - b - : 1 ± 1 mm

• Dimension - c - : 1 ± 1 mm

- Tighten the left and right screws to 4.5 Nm.

- Install the trim.

Adjust the rear glass sunroof panel

- Gently pull the inner seal - 3 - toward the inside on the marked locations - arrow - and loosen the screws - 2 - for the rear glass panel - 1 -.





- Adjust the rear glass panel - 2 - according to the illustration.





• Dimension - a - : 1.5 ± 1 mm

• Dimension - b - : 1 ± 1 mm

• Dimension - c - : 1 ± 1 mm

- Tighten the screws to 4.5 Nm.