Special Purpose Vehicle Control Module (J608)

Special Purpose Vehicle Control Module (J608)

Removing






- Switch the ignition off.

- Disconnect the battery ground (GND) cable from the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Open the cover for the left luggage compartment side trim panel.

- Disconnect the connector - 1 - on the control module.

- Push the clip - 3 - upward and move the special purpose vehicle control module - 2 - in the direction of the - arrow - out of the frame.

Installing

Install in reverse order of removal, observing the following:

- Connect battery. Required actions, refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.