Rear Housing

Housing






1 Cover

• Removing from the housing.

2 Magnet

• For vehicles with the keyless entry system

3 Housing

• Remove the screw from the clip.

• Using a screwdriver, press the retaining bracket and then remove the lock cylinder and cap.

4 Retaining Clip

• No replacement part, supplied with the mounting bracket

5 Cover

Removing





- Press the door seal to the side and remove the protective film over the hole - arrow A -.

- Remove the locking bolt - 4 - as far as the stop using a screwdriver - 1 -.

- Press the housing retaining bracket - 3 - inward.

- Remove the housing - 2 - from the mounting bracket - arrow B -.

Installation

To install, perform the steps used in removal in reverse order.

Remove the Housing Cap





- Remove housing. Refer to => [ Housing ] Rear Housing.

- Spread the clips - arrows - and remove the cover cap - 1 - from the housing - 2 - using an awl if necessary.

Installation

- Press the housing cover cap on until it engages audibly.