Hood Lock Cable Assembly Overview
Hood Lock Cable Assembly Overview
1 Hood Lock
• To adjust hood, slide up or down.
2 Hood Cable
• Removing
- Disconnect the release cable at the coupling.
- Disengage the release cable from the bracket - 7 -.
- Pull the release cable through to the engine compartment.
• Installing in reverse order
3 Cable Coupling
- Slide the coupling clamp sideways onto the bracket - 8 - on the lock carrier.
- Disconnect the release cable here before removing the lock carrier and release lever.
4 Lid Lock Rear Cable
• Release cable to the operating lever in the vehicle interior.
5 Grommet
• Ensure correct seating when installing.
6 Actuating Lever
• Disengage the release cable, refer to => [ Removing Hood Release Lever ] Hood Release Lever.
7 Hood Lock Release Lever
• Operating lever cover, removing => [ Hood Release Lever Cover, Removing ] Hood Release Lever
8 Electrical wiring
• Pull the electrical wire and the hood lock cable through the lock carrier as shown.
9 Cable Tie
Cable Coupling
1 Rear Cable
• Cable to the operating lever
• When removing, pull back out of the coupling.
2 Front Cable with Coupling
• To release, remove the clamp from the lock carrier and pull the cable back slightly out of the clamp.
• Fold the coupling up and lift the front cable with the end out of the coupling.
3 Lock Carrier
4 Clips
• Slide sideways onto the lock carrier after installing the cable.
Cable, Engaging in Hood Lock
1 Front Release Cable
• Insert the cable end in the operating lever in the hood lock.
• Install the cable and guide onto the hood lock from underneath.
2 Hood Lock
• Engage the release cable guide in the lower part of the hood lock.
3 Lock Carrier
4 Not Applicable
5 Cable Tie
• Secure the wire and cable to the lock carrier with a cable tie.
Release Cable, Engaging in Hood Lock
- Insert the release cable end - 2 - in the operating lever - arrow - in the hood lock - 3 -.
- Engage the release cable with guide - 1 - in the hood lock from below.