Rear Lid Assembly Overview

Rear Lid Assembly Overview






1 Gas-Filled Strut

• Noise insulation component must be installed on the body side.

2 Lid Hinge

• Removing, refer to=> [ Rear Lid Hinge ] Rear Lid Hinge

3 Rear Lid Control Module Motor

4 Rear Lid

• Remove rear lid trim.

• Disconnect the connectors and remove the hose for the rear window washer.

• Remove the rear lid motors on vehicles equipped with a power rear lid release. Refer to => [ Rear Lid Motor Assembly Overview ] Rear Lid Motor Assembly Overview

• Second person is required to support and lift hood.

• Remove gas-filled struts from rear lid.

• Remove the bolts on the left and right lid hinges.

• Lift the rear lid.

5 Cover

6 Rear Lid Lock

• Removing and Installing, refer to => [ Rear Lid Lock ] Rear Lid Lock

7 Nuts

• 21 Nm

8 Cover

9 Seal

10 Adjusting Buffer

• Adjusting, refer to=> [ Adjustment Buffer Installation
Position ] Rear Lid, Adjusting

11 Screws

• 8 Nm

12 Striker Pin

• Note different versions.

13 Nut

• 21 Nm

14 Stop

15 Bolt

• 8 Nm