Door Gap Covers

Door Gap Covers


• The adhesive surfaces on the body must be free of dirt and grease.

• Clean the adhesive surfaces using cleaning solution (D 009 401 04).

• Warm the adhesive areas to approximately 104 °F (40 °C) using a heat gun.

• After installing, take the roller and press the covers one more time.

Front Door Gap Cover





- Unclip the upper door gap cover - 1 - starting from the back toward the front and then pull it off the door flange.

- Clean any remaining adhesive from the door.

- Peel off the protective film from the two-sided adhesive tape.

- Position the cover on the door flange from underneath, align it so that it centered and then push it into the clips - 2 -.

Rear Door Gap Cover





- Removing and installing is same as on the front door.