Outer Door Sill Molding

Outer Door Sill Molding

• The protective molding is secured to the sidemember using adhesive strips.

• Removal cannot be done without destroying.






1 Door Seal

2 Rear Sill Panel Trim

• Removing

- Heat the door sill molding using a heat gun and pull the molding upward and off.

• Installing

- The sidemember must be free of dirt and grease in the adhesive area.

- Warm the sidemember in the adhesive area to approximately 104 °F (40 °C) using a heat gun.

- Remove protective film from adhesive tape.

- Insert the sill panel trim with the centering pins in the side member and press it on firmly in stages from front to back.

3 Front Sill Panel Trim

• Removal and installation same as with rear sill panel strip.

4 Adhesive Tape

• Pull off protective foil before installing.