Seat Angle Adjuster

Seat Angle Adjuster

Special tools, testers and auxiliary items required

• Seat Repair Stand (VAS6136)

Removing


• Follow all safety precautions when working on pyrotechnic components.

• Before handling pyrotechnic components (for example, disconnecting the connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.

- Switch the ignition on.

- Disconnect the battery ground cable with the ignition switched on.

- Remove the front seat. Refer to => [ Manual Standard Front Seat ] Manual Standard Front Seat.

- Attach the front seat to the (VAS 6136). Refer to => [ Front Seat, Installing on Seat Repair Stand ] Overhaul.

- Remove tunnel side trim panel. Refer to => [ Trim, Sill Side ] Trim, Sill Side.

- Remove the seat angle adjustment handle. Refer to => [ Seat Angle Adjustment Handle ] Seat Angle Adjustment Handle.

- Remove the shoulder pin - 2 -.






- Remove the bolt - 3 -.

- Remove the seat angle adjuster - 1 -.

Installation


• Follow all safety precautions when working on pyrotechnic components.

• Before handling pyrotechnic components (for example, connecting electrical connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.

Installation is reverse of removal, but note the following:

- Replace the shoulder pin - 2 - and the bolt - 3 -.

- Clean the threaded holes before installing, for example using a thread tap.

• Make sure the connectors are installed all the way in and are secure.


Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Connect the battery ground cable with the ignition turned on.

• If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again using the Vehicle diagnostic tester.

Tightening specifications, refer to => [ Seat Angle Adjuster Overview ] Seat Angle Adjuster Overview.