Access/Start Authorization Switch (E415)

Access/Start Authorization Switch (E415)

• If Access/Start Authorization Switch is replaced, it is not necessary to adapt immobilizer.

• Lock in Access/Start Authorization Switch is not mechanically coded.

• Therefore, when Access/Start Authorization Switch is replaced, key must not be replaced. Existing keys continue to work.

Removing






- Remove instrument cluster. Refer to => [ Instrument Cluster ] Instrument Cluster.

- Remove driver's side upper instrument panel cover.

- On USA vehicles, remove the right knee bar.

- Remove screws - arrows - and remove Access/Start Authorization Switch - item 1 - back from instrument panel.

- Disconnect electrical connectors - 1, 2, 3 -.






• Shown without retaining frame to provide a better illustration.

- Remove screws - arrows - and remove Access/Start Authorization Switch - item 1 - from retaining frame - 2 -.






Installing

Install in reverse order of removal, observing the following:

- Make sure all fasteners and electrical connectors are properly engaged.

- On USA vehicles, install the right knee bar.

- Install driver's side upper instrument panel cover.

- Install instrument cluster. Refer to => [ Instrument Cluster ] Instrument Cluster.

Tightening Specifications