Left Footwell Vent Temperature Sensor (G261)

Left Footwell Vent Temperature Sensor (G261)

• Installed only in vehicles with Comfort version A/C system

Removing

- Remove lower left instrument panel trim..

- Disconnect connector - B - from Left Footwell Vent Temperature Sensor - A -.






- Rotate Left Footwell Vent Temperature Sensor - A - approximately 90° in direction of arrow.

• If there is not enough room to rotate Left Footwell Vent Temperature Sensor - A -, disengage air channel to left footwell - E - from heating & A/C unit (remove air channel - C - and slide air channel to left footwell - E - slightly downward).

- Remove v - A - from air channel to left footwell - E -.

Installing

- Check O-ring seal - D - for damage and proper fitting.

- Insert Left Footwell Vent Temperature Sensor - A - on proper side into air channel mount - F -.

• An O-ring seal - D - is installed so that Left Footwell Vent Temperature Sensor fits without play in mount - F -.

- Connect connector - B - to Left Footwell Vent Temperature Sensor - A - and check wire routing.

- Install the remaining removed components again in reverse order.

- Check the DTC memory for the Climatronic control module (J255) and erase any faults displayed if necessary using the Vehicle diagnosis, testing and information system VAS 5051 in the "Guided Fault Finding" function.