Exhaust Gas Temperature Sensor 1

Exhaust Gas Temperature Sensor 1

Removing

- Carefully pull the engine cover - arrows - off the 4 bolts one after the other.






- Remove the bolts - 1 - and - 2 - and then remove the heat shield from the turbocharger.






- Disconnect the - 1 - exhaust gas temperature sensor 1 (G235) black connector and free up the wire.






• Ignore - 2 -.

- Remove the exhaust gas temperature sensor 1 - arrow -.






• To provide a better illustration, component location is shown from behind with engine removed.

Installing

Install in reverse order of removal. Note the following:

• Tightening specifications, refer to => [ Exhaust Temperature Control Overview ] Exhaust Temperature Control Overview.

- Coat the exhaust gas temperature sensor thread with hot bolt past; hot bolt paste, refer to the Parts Catalog.

• During installation, all cable ties must be installed at the same location.

- Install the turbocharger heat shield. Refer to => [ Turbocharger Overview ] Turbocharger Overview.