Bonded Rubber Bushing Flange and Driveshaft

Bonded Rubber Bushing Flange and Driveshaft

Removing

- Set the pneumatic/hydraulic foot pump (VAS 6179) on the lowest level.






- Pull out bonded rubber bushing.

• Pressure washer - A - off of the assembly tool (T10435)

Installing

- Place the bonded rubber bushing in its installed position on the front final drive.

• The little hole - A - and the big detent for the bonded rubber bushing - arrows - must be vertical to the final drive.






- Pull the bonded rubber bushings in enough so that this dimension - a - is achieved.






- Draw-in depth for the bonded rubber bushings






Dimension - a - = 47.5 mm