Trim, Sill Side

Trim, Sill Side

• Removal and installation can be performed with the front seat installed.

Removing






- Bring seat as far up as possible.

- Remove the backrest adjustment wheel. Refer to => [ Backrest Adjustment Wheel ] Backrest Adjustment Wheel.

- Remove seat height adjustment handle. Refer to => [ Seat Height Adjustment Handle ] Seat Height Adjustment Handle.

- Remove the expanding rivet - 2 - for the sill side trim - 1 -.

- Open the clips - 4 - (quantity: 2).






- Unclip trim - 1 - on retaining bracket - 3 -.

- Disengage trim in area of backrest adjustment wheel and seat anchor.

- Remove the trim forward and up from the retaining bracket.

• Make sure the bracket - 2 - and the tab - 2 - are not damaged when removing the trim.

Versions with four-way lumbar support:






- Disconnect the connector - 4 - from the driver seat lumbar support adjustment switch (E176) - 1 - on the tunnel side trim - 3 -.

Procedure for all manual seat versions:

- Remove sill side trim.

Installing






Install in reverse order of removal. Note the following:

• Make sure the tab - 2 - is seated correctly.

• Make sure the sill side trim - 1 - is engaged correctly on the retaining bracket - 3 - and the locking clips - 4 - are closed.

• Make sure the wire is as close to the connector - 4 - as possible.