Headrest Cover

Headrest Cover

Special tools, testers and auxiliary items required

• Trim Removal Wedge (3409)

• It is only possible to replace the cover on the headrest with a leather cover. It is not possible to replace a fabric headrest cover because the cover is filled with foam and also serves as the casing for the upholstery.

• The headrest support is built into the upholstery. Both components are attached to each other and cannot be separated.

Removing






- Remove the headrests => [ Headrest ] Headrest.

- Press the sides of the upholstery away from the trim - 1 - in the direction of the - arrow -.

- Bend the leg spring - 2 - up slightly using a wide screwdriver.

- Pull the trim up at one side at the same time until it disengages on one side.

- Perform the same step on the other side.

- Remove the trim while bending the leg spring up.

- Open the locking channel - 1 - and - 2 -.






- Remove the cover - 3 - from the support with the upholstery.

Installing






- Install cover - 1 -.

- Position the cover and slide it over the support with upholstery - 2 -.

- Pull the left and right corners of the cover - arrow - over the support with upholstery - 2 -.






- Pull the cover so it is smooth.

- Engage the locking channel - 1 -.

- Bend the leg spring - 2 - up while sliding the trim - 1 - on.






- Hold the leg spring - 2 - open until the trim - 1 - slides over the notches into the locked position.

- Press the trim on firmly until it engages.

- Align the cover - 3 - and pull it so it is smooth.

- Make sure the cover lies on the upholstery without any wrinkles and without seam markings.

Further installation is performed in the reverse order of removal.