Lower Transverse Link

Lower Transverse Link

Special tools, testers and auxiliary items required

• Torque Wrench 5-50 Nm (V.A.G 1331)

• Torque Wrench 50-200 Nm (V.A.G 1332)

Removing






- Determine dimension - a - from the center of the wheel to the lower edge of the wheel housing before starting work while the vehicle is resting on its wheels.

- Place the vehicle on a hoist.

- Remove the wheel.

- Remove coil spring. Refer to => [ Coil Spring ] Service and Repair.

- On vehicles with a level control system sensor - 1 -, remove the bolt - 2 -.






- Remove bolt - 4 -.






- Remove nut - 3 -.






- Remove the bolt - 1 - and the spacer tube - 2 -.

• Axle alignment is necessary if the nut - 3 - is loosened or the bolt - 1 - is removed.

- Remove bolt - 1 -.






- Remove the nut - 3 - and bolt - 2 -.

- Remove lower transverse link.

Installing

Install in reverse order of removal. Note the following:

Tightening specifications, refer to => [ Upper Transverse Link, Tie Rod, Coil Spring, Lower Control Arm and Level Control System Sensor Overview ] Upper Transverse Link, Tie Rod, Coil Spring, Lower Control Arm and Level Control System Sensor Overview

• Bonded rubber bushings can only be turned to a limited extent. Only tighten suspension bolts when the vehicle is in curb weight or control position.

• Wheel bearing, lifting to curb weight position on vehicles with coil springs. Refer to => [ Wheel Bearing in Curb Weight, Lifting Vehicles with Coil Spring ] Description and Operation.

- Insert the lower control arm and install the bolt - 1 - loosely.






• To make sure there is enough clearance to tighten the bolt - 2 -, the trim and the wheel spoiler must be removed.

- Install the bolt - 2 - and install the nut - 3 - loosely.

- Insert the bolt - 1 - with the spacer tube - 2 - and install the nut - 3 - loosely.






• Do not tighten the threaded connection using the nut - 3 -.

- Tighten the bolt - 1 -.

- Tighten the rest of the threaded connections.

- Install coil spring. Refer to => [ Coil Spring ] Service and Repair.

- Tighten the wheel.

- Axle alignment is required, see table, refer to => [ When Vehicle Alignment is Necessary ] Description and Operation.

The axle alignment on the front and rear axles must be performed on a VW/Audi approved alignment rack.

- On vehicles with automatic headlamp range control system, perform a basic setting on the headlamps.

- If the vehicle level sensor was removed and installed on a vehicle with electronically controlled damping or if the linkage was loosened, the control position must be reprogrammed. Refer to => [ Programming Control Position using ] Testing and Inspection. Vehicle diagnostic tester.

- If the control position was reprogrammed on vehicles with lane assist, the directional stabilization assistance control module (J759) must be recalibrated. Refer to => [ Calibration Procedure ] Calibration Procedure.