Hydraulic Pump

Hydraulic Pump

The hydraulic system is under pressure, which can cause serious personal injury.

• The hydraulic pressure within the system must be released before starting any work on the convertible top system.

Removing






- Close the convertible top all the way.

- Turn off the ignition and press the convertible top operation switch (E137) - 1 - for approximately 5 seconds.

• The pressure in the hydraulic system will come down.

- Follow cleanliness rules. Refer to => [ Clean Working Conditions ] Clean Working Conditions.

- Remove the left luggage compartment side trim..






- Disconnect the connectors - 2, 3, 5 - from the bracket.

- Remove the nut - 1 - and bolt - 6 - and then remove the bracket - 4 -.

- Remove the hydraulic pump and the adhesive strips - 3, 4 -.






- Remove the upper section of the noise insulation - 2 -.

- Remove the hydraulic pump from the lower section of the noise insulation - 1 -.

- If the reservoir and hydraulic pump are being replaced:

• Removing the hydraulic line, refer to => [ Hydraulic Line On Valve Block ] Hydraulic Line On Valve Block.

Installation

• Tightening specifications, refer to => [ Hydraulic Pump, Tightening Specification ] Motor Overview and Hydraulic Pump Fluid Reservoir.

Install in reverse order of removal. Note the following:

- Install the hydraulic line, refer to => [ Hydraulic Line On Valve Block ] Hydraulic Line On Valve Block.

- Hydraulic system, filling and bleeding, refer to => [ Hydraulic System, Filling and Bleeding ] Hydraulic System, Filling and Bleeding.

- Install the left luggage compartment trim panel..