Operation CHARM: Car repair manuals for everyone.
Home >> Audi >> 2011 >> S5 Quattro Cabriolet (8F7) V6-3.0L SC (CCBA) >> Repair and Diagnosis >> Body and Frame >> Seats >> Service and Repair >> Removal and Replacement >> Manual Standard Front Seats >> Seat Forward/Back Adjuster Release Cable

Seat Forward/Back Adjuster Release Cable







Seat Forward/Back Adjuster Release Cable

Removing


• Follow the safety precautions for pyrotechnic components. Refer to => [ Restraint System Components ] Description and Operation.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Remove front seat:

• Standard and Sport Manual Seat. Refer to => [ Manual Standard Front Seats ] Manual Standard Front Seats.

- Attach front seat to Fixture For Seat Repair (VAS 6136). Refer to => [ Front Seat, Installing on Fixture for Seat Repair VAS 6136 ] Front Seat, Installing on Fixture for Seat Repair VAS 6136.





- Open the cable ties for the release cable or unclip the clip on the seat pan.

- Disengage the release cable bracket - 1 - on the seat forward/back adjustment - 2 -.

- Disengage the end of the release cable - arrow - at the seat forward/back adjuster lever - 3 -.

- Disengage the release cable bracket - 2 - on the seat forward/back adjustment - 2 -.





- Disengage the release cable - 1 - that seat forward/back release cable mount - arrow A -.





- Disengage the ball-shaped end of the release cable - arrow B - at the seat forward/back adjuster groove.

- Remove the release cable.

Installation


• Follow the safety precautions for pyrotechnic components. Refer to => [ Restraint System Components ] Description and Operation.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

Installation is reverse of removal, but note the following:

• Ensure that electrical connections are pushed in as far as stop and engage with a click.


Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Disconnect the battery ground wire with the ignition switched on. Refer to.

• If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.
pro multis · About Operation CHARM