Exterior Mirror Turn Signal Lamp (L131)/(L132)

Exterior Mirror Turn Signal Lamp (L131)/(L132)

Removing






- Remove the mirror adjuster..

• To protect the paint in the area around the mirror housing, tape it off with a soft cloth.

- Remove the screws - 4 and 5 -.

- Open the clips - 2 - and remove the exterior mirror housing - 3 - from the cover - 1 - - arrows -.

- On vehicles with lane change assist, pull the exterior mirror housing - 1 - just far enough until the connector is visible.






- Disconnect the electrical connector - 2 - for the lane change assist warning lamp on the front side of the mirror adjusting unit mount - 3 -.

- Pull the exterior mirror housing - 2 - upward and disconnect the connector - 3 -.






- Remove the screws - 1 and 4 -.

- Tilt the turn signal housing - 5 - out of the exterior rearview mirror housing - arrow -.

Installing






• Tightening specifications, refer to => [ Exterior Rearview Mirror Turn Signal Overview ] Service and Repair.

Install in reverse order of removal, observing the following:

• The entire exterior mirror turn signal must be replaced if a Light Emitting Diode (LED) is faulty.

- Insert the tip of the turn signal - 3 - into the opening in the exterior mirror housing - 4 - - arrow -.

- Place the turn signal bulb housing - 2 - into the outside mirror housing; make sure the groove fits into the guide - 1 -.

- Install the exterior rearview mirror housing..