Accelerator Pedal Module with Accelerator Pedal Position Sensor

Accelerator Pedal Module with Accelerator Pedal Position Sensor

Removing

- Remove the driver side lower instrument panel cover.

- Disconnect the electrical connector - 2 - by pressing the release - 1 - up - arrow -.





- Remove the bolt - 3 - and remove the accelerator pedal module downward.

Installing

• Tightening specifications, refer to => [ Accelerator Pedal Module Assembly Overview ] Accelerator Pedal Module Assembly Overview.

Installation is in reverse order of removal, note the following:

- Engage the accelerator pedal module - 4 - on the bottom of the pedal bracket - 1 -, insert the centering pin - 2 - and tighten the bolt - 3 -.





- Install the driver side lower instrument panel cover.

- Perform after the first kick-down adaptation in Guided Functions [ext-diag]^^[ext-diag]^^^^[/ext-diag]