Backrest Heating Element, Standard Seat

Backrest Heating Element, Standard Seat

Removing






- Remove cover and cushion from backrest, refer to => [ Backrest Cover and Upholstery ] Backrest Cover and Upholstery.

- Disconnect cover from upholstery => [ Backrest Cover and Upholstery, Separating and Connecting ] Backrest Cover and Upholstery, Separating and Connecting.

- Cut the wire - 3 - off directly at the old backrest heating element - 2 -.

• The old backrest heating element remains on the upholstery - 1 - and the new backrest heating element is bonded over it.

Installing

- Align the new backrest heating element on the upholstery.

• Make sure the new backrest heating element is affixed to the old heating element.

• Remove the protective films in the bonding sequence for the heating element area.

• When removing the protective film, make sure the heating element is not damaged and that it is attached without wrinkles.

- Bond the individual areas of the heating element in the sequence - A -, - B - and - C -.






- Route the connecting wires to the individual heating surfaces in the base of the gaps - arrow -.

- Pull the wire - 3 - through the slit in the upholstery - 1 -.

Further installation is performed in the reverse order of removal.