Entry Assistance Release Cable A

Entry Assistance Release Cable A

Removing

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Safety Precautions ] Service Precautions.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Turn on the ignition.

- Disconnect the battery ground (GND) cable from the battery.

- Remove the front seat:

• Standard seat and Sport seat (manual). Refer to => [ Manual Standard Front Seat ] Manual Standard Front Seat.

- Attach the front seat to the fixture for seat repair (VAS 6136). Refer to => [ Front Seat, Installing on the ] Front Seat, Installing on the Fixture For Seat Repair (VAS 6136).

- Remove tunnel side trim panel. Refer to => [ Trim, Tunnel Side ] Trim, Tunnel Side.

- Move the backrest forward as far as the stop using the handwheel.

- Disengage the entry assistance release cable A - 1 - at the backrest hinge.






- Remove the entry assistance release cable A guide - 2 - from the seat frame.

- Unclip the control cable bracket of the entry assistance release cable A - 1 - at the seat forward/back adjuster - 2 -.






- Disengage the entry assistance release cable A - 1 - at the seat forward/back adjuster - 2 - and remove it.






Installing

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Safety Precautions ] Service Precautions.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

Make sure the backrest is in the basic position, i.e. it must be moved forward as far as the stop using the handwheel.

- Engage the entry assistance release cable B - 1 - in at the seat forward/back adjuster - 2 -.

- Clip the control cable bracket of the entry assistance release cable A - 1 - into seat forward/back adjuster - 2 -.






- Engage the entry assistance release cable A - 1 - at the backrest hinge.






- Install the entry assistance release cable A guide - 2 - on the seat frame.

- Adjust the entry assistance release cable A. Refer to => [ Entry Assistance Release Cable A, Adjusting ] Entry Assistance Release Cable A, Adjusting.

- Lock the entry assistance release cable A - 1 - with the clip - 2 -.






Further installation is performed in reverse sequence of removal, but observe the following:

• Make sure the connectors are installed all the way in and are secure.

Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Connect the battery ground (GND) cable with the ignition turned on.

• If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again using the vehicle diagnostic tester.