Entry Assistance Trim

Entry Assistance Trim

• Removal and installation can be performed with the front seat installed.

Special tools, testers and auxiliary items required

• Trim Removal Wedge (3409)

Removing






- Press the handle - arrow B - forward as far as the stop and hold it in that position.

- Press the tab - arrow A - off the catch - arrow C - in the direction of the - arrow - using a trim removal wedge (3409).

- Perform the same step on the opposite side of the trim - 1 -.

- Tilt the trim - 1 - upward diagonally and remove from the handle with the bracket - 2 -.

- Disengage the rear trim catch from the handle with bracket.

- Remove the trim - 1 - from the handle with bracket - 2 - as far as the length of the entry assistance button wire allows.

- Disconnect the electrical connector - 1 - on the entry assistance button - 2 -.






- Remove the trim - 3 - with the entry assistance button.

- Remove the entry assistance button. Refer to => [ Entry Assistance Button ] Entry Assistance Button.

Installing

- Install the entry assistance button.

- Connect the connector to the entry assistance button.

• Make sure the connectors are installed all the way in and are secure.

- First engage the rear trim retaining tab in the handle with bracket.

- Make sure the trim engages correctly in the handle with bracket.