Right Engine Mount

Right Engine Mount

• To avoid repeat repairs, do the following if the engine mount is faulty:

• Replace the faulty engine mount and its retaining plate.

• Likewise replace the engine mount on the opposite side, check the retaining plate and replace it if necessary.

Special tools, testers and auxiliary items required

• Engine Support Bridge (10 - 222 A)

• Spindle (10 - 222 A /11)

• Engine Support Supplement Set (T40093)

Removing






• The engine mounts must be replaced in pairs.

- Remove the engine cover - arrows -.

- Remove the generator.






- Install the (10 - 222 A) with adapter (T40093/6) on the left and right strut towers, as shown in the illustration.






- Engage the (10 - 222 A /11) on the right rear engine lifting eye.

- Lightly pretension the engine using the spindle.

- Remove the nut - arrow - on the right longitudinal member and free up the ground wires.






- Disconnect and free up the connector - 2 - from the oil level thermal sensor (G266).






- Disconnect the electrical connector - 2 - on the right electrohydraulic engine mount solenoid valve (N145) and free up.






- Remove the right engine support retaining plate bolts - 1, 4 and arrows -.

- Free up the electrical wiring harness located on the right engine mount retaining plate - 3 -.

- Move the engine mount retaining plate to the side.

- Raise the engine by dimension - a - using the (10 - 222 A /11).






• Dimension - a - = approximately 20 mm.

- Remove the right engine mount.

Installing

Install in reverse order, paying attention to the following:

• For the correct tightening specifications, refer to => [ Subframe Mount Overview ] Subframe Mount Overview.

• Replace bolts that are tightened to the specification.

• When installing, bring all cable ties back to the same positions.

- Install the wires.

- Install the generator.