Timing Chain Covers Overview
Timing Chain Covers Overview
1 Bolt
• Tightening specification and sequence, refer to => [ Lower Timing Chain Cover, Tightening Specifications and Sequence ]
2 Crankshaft Shaft Seal, Transmission Side
• Removing and installing, refer to => [ Crankshaft Seal, Transmission Side ] Service and Repair
3 Alignment Bushing
• Quantity: 2
4 Lower Timing Chain Cover
• Removing and installing, refer to => [ Lower Timing Chain Cover ] Lower Timing Chain Cover
5 Left Cylinder Head Gasket
6 Bracket
• For the electrical wiring harness
7 Bolts
• Tightening specification and sequence, refer to => [ Left Timing Chain Cover, Tightening Specifications and Sequence ]
8 Bracket
• For the left oxygen sensors electrical connectors
9 Left timing Chain Cover
• Removing and installing, refer to => [ Left Timing Chain Cover ] Left Timing Chain Cover
10 O-ring
• Replace
11 Left Coolant Intermediate Pipe
• Remove using a drift
12 O-ring
• Replace
13 Bolt
• Tightening specification and sequence, refer to => [ Right Timing Chain Cover, Tightening Specifications and Sequence ]
14 Bracket
• For the right oxygen sensors electrical connectors
15 O-ring
• Replace
16 Right Coolant Intermediate Pipe
• Remove using a drift
17 Right Timing Chain Cover
Removing and installing, refer to => [ Right Timing Chain Cover ] Right Timing Chain Cover
18 Right Cylinder Head Gasket
19 Alignment Bushing
• Quantity: 2
20 Engine Speed (RPM) Sensor (G28)
21 Bolt
Left Timing Chain Cover, Tightening Specifications and Sequence
- Tighten left timing chain cover bolts to 9 Nm in sequence. - 1 to 8 -
• The brackets - arrows A, B - are connected with the left timing chain cover.
Right Timing Chain Cover, Tightening Specifications and Sequence
- Tighten right timing chain cover bolts to 9 Nm in sequence - 1 to 8 -.
• The bracket - arrow - is connect with the right timing chain cover.
Lower Timing Chain Cover, Tightening Specifications and Sequence
• Replace bolts that are tightened to the specification.
- Tighten bolts in 6 stages as follows:
