Exterior Mirror Turn Signal Lamps, Through 05.09

Exterior Mirror Turn Signal Lamps, through 05.09

Removing





- Remove the exterior mirror.

• To protect the paint in the area around the mirror housing, tape it off with a soft cloth.

- Remove the bolts - 4 - and - 5 -.

- Release the retaining tabs - 3 - in the - direction of arrow A -.

- Release the retaining clip - 1 - and remove the exterior rearview mirror housing from the cover - 2 - - B arrows -.

- Press the mirror adjusting unit down and remove the exterior rearview mirror housing upward.





- If applicable, disconnect the lane change assistance warning lamp electrical connector - 2 - on the front side of the mirror adjusting unit mount - 3 -.

- Pull the exterior mirror housing upward and disconnect the electrical connector - 3 -.





- Remove screws - 1 - and - 4 -.

- Tilt the turn signal housing - 2 - out of the exterior rearview mirror housing - arrow -.

Installing

• Tightening specifications, refer to => [ Exterior Rearview Mirror Turn Signals Assembly Overview, through 05.09 ] Exterior Rearview Mirror Turn Signals Assembly Overview, Through 05.09.

Install in reverse order of removal, observing the following:

• The entire exterior mirror turn signal must be replaced if an LED is faulty.

- Insert the tip of the turn signal in the slit in the exterior rearview mirror housing - 3 - - arrow A -.

- Tilt the turn signal bulb housing - 4 - into the exterior rearview mirror housing - arrow B -. The locking tab - 2 - must engage in the mount - 1 -.

- Install the exterior rearview mirror housing.