Fuel Tank With Attachments Overview

Fuel Tank with Attachments Overview






1 Bolt

2 Exhaust System Suspended Mount

3 Mounting Strap

4 Fuel Line

• From the fuel filter to the engine

• Do not kink

• Clipped to the fuel tank

• To disconnect, press release button on connection piece

5 Bolt

• 8 Nm

6 Protective Plate

• For the fuel filler tube

7 Overflow Hose

• Attached to the bumper bracket

8 Rubber Gasket

9 Cap

• Turn until it clicks and locks.

• Attached to tank flap unit with fastening device

10 Bolt

• 20 Nm

• To attach the fuel filler neck

• For discharging electrostatic charge, refer to => [ Fuel Filler Tube Ground Connection ]

11 Fuel Tank

• Removing and Installing, refer to => [ Fuel Tank with Attachments ] Fuel Tank With Attachments

12 Vent Line

• To the Evaporative Emission (EVAP) canister

• Do not kink

• To disconnect, press release button on connection piece

• Clipped to the fuel tank

13 Fuel Tank Heat Shield

14 Nut

• 2 Nm

15 Nut

• 2 Nm

16 Carrier Plate

17 Fuel Tank Heat Shield

18 Nut

• 2 Nm

19 Bolt

• 20 Nm

20 Nut

• 2 Nm

21 Expanding Clip

Locking Flange Cover - Tightening Specifications





- Tighten bolts - arrows - to 1.5 Nm.

Fuel Filler Tube Ground Connection





- Make sure the filler tube threaded connections - 1 and 2 - are free of corrosion so the Ground (GND) connection to the body is not affected.


Risk of explosion due to electrostatic charge.

• After installing, check electrical connection on fuel filler neck metal ring to an empty spot on the body using an Ohm meter.

• Specified value: approximately 0 ohms.