Child Seat Anchorage, Checking Function

Child Seat Anchorage, Checking Function

To check function, you must install entire belt system, including side trim.

Switching Hold Function On

• Pull belt webbing out completely up to stop.

Correct Function

• Belt must retract with a chattering sound.

• If retracting process is stopped, belt cannot be pulled out anymore.

Deactivating

• Belt retraction to about 100 mm remaining.

• The hold function must switch off when there is at least 100 mm remaining. The belt will function normally again.

Incorrect Function

• If the seat belt child seat anchorage does not work, replace the seat belt