Camshaft Position Sensor: Service and Repair

Camshaft Position Sensor

For the locations of the four camshaft position sensors. Refer to => [ Component Location Overview ] Component Location Overview.

- Disconnect the electrical connector on the respective camshaft position sensor.

• The following camshaft position sensors are installed in cylinder bank 1 (right): Camshaft Position (CMP) Sensor (G40) and Camshaft Position (CMP) Sensor 3 (G300)

• The following camshaft position sensors are installed in cylinder bank 2 (left): Camshaft Position (CMP) Sensor 2 (G163) and Camshaft Position (CMP) Sensor 4 (G301)

- Remove the air filter housing to remove the Camshaft Position (CMP) Sensor 3 (G300) on cylinder bank 1.

- Remove the coolant reservoir to remove the Camshaft Position (CMP) Sensor 4 (G301) on cylinder bank 2.

Installing

• Replace the O-ring if damaged

- Coat the O-ring with engine oil and carefully press the camshaft position sensor in by hand.

- Tighten the camshaft position sensor and connect the electrical connector.

• Camshaft position sensor tightening specification. Refer to => [ Ignition Assembly Overview ] Service and Repair.

- Further installation is performed in reverse order.