Door Window

Door Window

Removing






Proceed as follows:

- Remove the door trim.

- Remove the sealing plugs - 2 and 4 -.

- Run the door window down until the bolts in the opening are visible.

- Remove the bolts - 1 - but only loosen the bolt - 5 -.

• Remove the rear bolt - 1 - completely. Otherwise, the door window cannot be removed.

- Tilt the rear door window - 3 - toward the outside out of the mount in the clamping brackets.

- Remove the door window upward out of the clamping bracket and remove it from the door - arrow -.

Installing

• Gap dimensions, refer to => [ Door Window Gap Dimensions ] Door Window Gap Dimensions.

• For the correct tightening specifications, refer to => [ Window Regulator Motor and Window Regulator Overview ] Window Regulator Motor and Window Regulator Overview.

Install in reverse order of removal. Note the following:

- Insert the door window forward into the door window guide diagonally and then rotate it back into the door shaft.

- Carefully side the door window parallel down into the clamping brackets. Make sure the door window in the front window guide does not slip out.

- Press the door window down into the clamping brackets.

• Before installing the rear bolt, make sure the door window is seated in the clamping bracket mount.

- Tighten the bolts.

- Adjust the door window. Refer to => [ Door Window, Adjusting ] Door Window, Adjusting.