Upper Rear Lid Trim

Upper Rear Lid Trim

Removing

- Remove lower rear lid trim. Refer to => [ Lower Rear Lid Trim ] Lower Rear Lid Trim.

- Remove left and right wiring harness clamp - 1 -.






- Remove left and right bolts - 2 -.

Only if the upper rear lid trim - 4 - should be replaced:

- Remove ball stud - 3 - on left and right sides.

- First, pull left and right of upper lid trim - 4 - down in direction of - arrow A -.

- Then pull upper lid trim - 4 - up in direction of - arrow B - with a 2nd technician.

Installation

Install in reverse order of removal. Note the following:

• If trim clamps remain in body mounting points, remove these and insert them in trim.

• Check clamps for damage or deformation, replace if necessary.

- Position upper rear lid trim panel with a 2nd technician. Press rear lid trim on from bottom to top.

For the correct tightening specifications; refer to => [ Rear Lid Trim Assembly Overview ] Rear Lid Trim Assembly Overview.