Anti-Roll Bar Trim

Anti-roll Bar Trim

Special tools, testers and auxiliary items required

• Trim removal wedge (3409)






Removing

• The rear bulkhead cover is only laid aside and is not removed completely.

Loosen the rear panel cover (without detaching the seat belts from the belt end fittings), refer to => [ Rear Bulkhead Cover Assembly Overview ] Rear Bulkhead Cover Assembly Overview and move it to the side.

- Remove clamps - 1 - from front part of rollover protection trim - 2 - and body.






- Beginning at the bottom, unclip the front part of the rollover protection trim - 2 - from the rollover protection using the Trim Removal Wedge (3409).

- Remove bolts - arrows - and remove rollover protection bracket - 3 -.

- Remove back part of rollover protection trim - 4 - from rollover protection.

Installation

Install in reverse order of removal.

For the correct tightening specifications; refer to => [ Rollover Protection Trim Assembly Overview ] Rollover Protection Trim Assembly Overview.