Fuel Delivery Unit and Fuel Level Sensor (G) Overview
Fuel Delivery Unit and Fuel Level Sensor (G) Overview
1 Fuel Level Sensor (G)
• Check the resistance values. Refer to => [ Fuel Level Sensor (G), Checking ] Fuel Level Sensor (G), Checking
• Removing and Installing, refer to => [ Fuel Level Sensor (G) ] Fuel Level Sensor (G)
2 Fuel Delivery Unit with Locking Flange
• Fuel pump electrical, checking, refer to => [ Fuel Pump Electrical, Checking ] Fuel Pump Electrical, Checking
• Removing and Installing, refer to => [ Fuel Delivery Unit ] Fuel Delivery Unit
• Fill the fuel tank with at least 5 liters of fuel.
3 Seal
• Replace
• Install dry
4 Fuel Supply Line
• To fuel filter
• Do not kink
• Attaches to connection with identification "V" at sealing flange
• To remove from locking flange, press release button
5 Fuel Return Line
• From the fuel filter
• Do not kink
• Attaches to connection with identification "R" at sealing flange
• To remove from locking flange, press release button
6 Electrical Harness Connector
• For transfer fuel pump (G6) and fuel level sensor
7 Locking Ring
• 110 Nm
• Use wrench (T10202) for removing and installing
8 Fuel Delivery Line
• From the suction jet pump to the fuel delivery unit
• Clipped to the fuel delivery unit
9 Electrical Harness Connector
• For fuel level sensor 2 (G169)
10 Locking Ring
• 110 Nm
• Use (T10202) for removing and installing
11 Seal
• Replace
• Install dry
12 Fuel Level Sensor 2 (G169)
• Only available together with - 13 -
• Installed position => [ Press locking flange down against the spring pressure and bring it into installation position. ] Fuel Level Sensor 2 (G169)
• Check the resistance values. Refer to => [ Fuel Level Sensor 2 (G169), Checking ] Fuel Level Sensor 2 (G169), Checking
• Removing and installing, refer to => [ Fuel Level Sensor 2 (G169) ] Fuel Level Sensor 2 (G169)
13 Suction Jet Pump
• With lines
• Only available together with - 12 -
• Removing and installing, refer to => [ Suction Jet Pump ] Suction Jet Pump
14 Suction Jet Pipe
• From fuel pump to suction jet pump
• To disconnect, press release button on connection piece