Fuel Tank with Attachments Overview

Fuel Tank with Attachments Overview






1 Nut

• 23 Nm

2 Fuel Tank Heat Shield

• With carrier plate

3 Nut

• 23 Nm

4 Fuel Line

• To engine

• To disconnect, press release button on connection piece

5 Vent Line

• From the EVAP canister to Evaporative Emission (EVAP) canister purge regulator valve 1 (N80)

• Clipped in on fuel tank

6 Electrical Harness Connector

• For transfer fuel pump (G6) and fuel level sensor (G)

7 Protective Plate

• For fuel delivery connection

8 Bolt

• 11 Nm

9 Cover

• Attached to the fuel tank insert with a fastening device

10 Ground Connection

• For discharging electrostatic charge

• Installed position, refer to => [ Fuel Filler Tube Ground Connection and Protective Plate ]

• Make sure the connector is securely seated.

• After installation, check electrical connection from fuel filler tube protective plate - 7 - to an empty place on the body using an Ohm meter; specified value: Approximately 0 ohms

11 Vent Line

• From gravity valve to EVAP canister

• Clipped in on bracket in wheel housing

• To disconnect, press release button on connection piece

12 Pop Rivet

13 Fuel Tank

• Removing and Installing, refer to => [ Fuel Tank with Attachments ] Fuel Tank with Attachments

14 Mounting Strap

• Installed position: Locating point (hole) points in driving direction

Fuel Filler Tube Ground Connection and Protective Plate





- Ensure filler tube threaded connections - 2 and 4 - are free of corrosion so the Ground (GND) connection to the body is not affected.

- Route GND connection - 1 - as shown in illustration.

- Ensure GND connection connector - arrows - is seated firmly on protective plate - 5 - and on filler tube - 3 -.

Risk of explosion due to electrostatic charge.

• After installing, check electrical connection on fuel filler neck metal ring to an empty spot on the body using an Ohm meter.

• Specified value: Approximately 0 ohms.