Parking Assist Control Module

Parking Assist Control Module

Component location is in luggage compartment at rear, right side, below side trim

Removing

- If the control module was replaced, select the Replace function for the respective control module in Guided Fault Finding or Guided Functions.

- Select the function or path






- Follow the instructions on the Vehicle Diagnosis Tester display.

- Switch off ignition and remove ignition key.

- Remove luggage compartment right side trim.

- If equipped, disconnect the connectors - 2 - and - 3 -.






- Release clip - arrow - and pull towing recognition control module (J345) - item 1 - out of mounting frame.

- Disconnect electrical connectors - 2 - and - 3 -.






- Release clip - arrow - and pull park assist control module (J446) - item 1 - out of mounting frame.

Installing

Install in reverse order of removal, noting the following:

If the park assist control module was replaced, then it must be re-coded.

- Select the function or path






- Follow the instructions on the Vehicle Diagnosis Tester display.

- Install luggage compartment right side trim.