Backrest Adjustment Motor

Backrest Adjustment Motor

Removing


• Follow the safety precautions for pyrotechnic components.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Remove the backrest. Refer to => [ Backrest ] Backrest.

- Remove backrest cover panel. Refer to => [ Backrest Cover ] Backrest Cover.

- Remove cover with upholstery. Refer to => [ Backrest Cover and Upholstery ] Backrest Cover and Upholstery.

- Pry off the spring washer - 1 - on the side of the backrest adjustment motor using a screwdriver.





- Remove the bolt - 2 -.

- Remove the shaft - 5 - out the backrest frame far enough - arrow - until the backrest adjustment motor - 3 - is comes out.

- Disconnect electrical harness connector - 4 -.

- Remove the backrest adjustment motor.

Installation


• Follow the safety precautions for pyrotechnic components.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Slide shaft - 5 - through backrest adjustment motor and backrest frame.





- Secure the backrest adjustment motor - 3 - with the bolt - 2 -.

- Place the backrest frame to the side.

- Place a wood block under the shaft - 5 - on the opposite side of the backrest adjustment motor.

- Drive the spring washer - 1 - onto the shaft using a socket insert (11 mm).

Further installation is performed in reverse sequence of removal, but observe the following:

• Ensure that electrical connections are pushed in as far as stop and engage with a click.


Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Disconnect the battery ground wire with the ignition switched on.

• If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.

Tightening specifications, refer to => [ Backrest Adjustment Motor Component Overview ] Backrest Adjustment Motor Component Overview.