Memory Seat/Steering Column Adjustment Control Module
Memory Seat/Steering Column Adjustment Control Module
Special tools, testers and auxiliary items required
• Trim Removal Wedge (3409)
Removing
• Follow all safety precautions when working on pyrotechnic components.
• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.
- Remove the front seat:
• Standard and sport power seat, comfort seat and super sport seat. Refer to => [ Power Standard Front Seat ] Power Standard Front Seat.
- Attach the front seat to the (VAS 6136). Refer to => [ Front Seats, Installing on the ] Front Seats, Installing on the Fixture For Seat Repair (VAS 6136).
- Disconnect the connectors - 2 through 5 - on the control module - 1 -.
- Unclip the tabs - arrows - using the (3409).
- Carefully remove the control module - 1 - from the retainers - arrow -.
- Disengage the hooks - 2 - and - 3 - on the bracket - 4 - and remove the control module.
Installing
• Follow all safety precautions when working on pyrotechnic components.
• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.
Install in reverse order of removal. Note the following:
• Make sure the memory seat adjustment control module engages audibly in the retainer.
• Make sure the connectors are installed all the way in and are secure.
Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.
- Connect the battery ground cable with the ignition turned on.
• If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again using the Vehicle Diagnostic Tester.