Rear Side Airbag Crash Sensor

Rear Side Airbag Crash Sensor

Removing

Follow all safety precautions when working on pyrotechnic components.

- Turn on the ignition.

- Disconnect the battery ground cable from the battery with the ignition on.

- Remove the rear side airbag. Refer to => [ Driver Side Rear Thorax Airbag Igniter (N201) and Front Passenger Rear Thorax Airbag Igniter (N202) ] Driver Side Rear Thorax Airbag Igniter (N201) and Front Passenger Rear Thorax Airbag Igniter (N202).

- Remove the side cushion. Refer to => [ Side Upholstery ] Side Upholstery.

Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.

- Release the lock - 1 - - arrow - and disconnect the connector - 41 -.

- Remove the nuts - 3 - and the side airbag crash sensors - 2 -.

Installing

• Follow all safety precautions when working on pyrotechnic components.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.

Install in reverse order of removal. Note the following:

• Make sure the connectors are installed all the way in and are secure.

• Make sure the wires do not get caught.

Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Connect the battery ground cable with the ignition turned on.

• If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again using the Vehicle Diagnostic Tester.

Tightening specifications, refer to => [ Airbag Crash Sensors Overview ] Airbag Crash Sensors Overview.