Fuel Injection and Ignition

Engine Speed Sensor (G28)

Special tools, testers and auxiliary items required

• Socket 4 mm (T10370)

• Assembly Tool (T10118)

Removing

- Disconnect the connector on the Engine Speed (RPM) Sensor (G28) - 2 - using (T10118).

• To release the connector without the (T10118) , push the connector against the RPM sensor and simultaneously lift up on the release tab with a thin wire hook.

- Use a socket wrench with a (T10370) to remove the bolt - 1 -.






Installing

Install in reverse order of removal. Note the following:

• Tightening specifications: Component locations overview, refer to => [ Component Locations Overview ] Component Locations Overview