Removal and Installation

Wheel Bearing Unit

Removing

- Remove wheel bearing housing. Refer to => [ Wheel Bearing Housing ] Wheel Bearing Housing.

- Clamp the wheel bearing housing in a vise with aluminum protective covers.

- Remove the bolts - 1 - and the wheel bearing unit - 2 -.






• Avoid contaminating with dirt and damaging the seal when setting down/storing.

The wheel bearing - 1 - must always face up.






- Always set the wheel bearing unit down on the wheel hub - 2 -.

The same procedure also applies to the wheel bearing without a wheel hub.

Installing

Install in reverse order of removal. Note the following:

Tightening specifications, refer to => [ Wheel Bearing Housing, Wheel Bearing Unit and Coil Spring Shock Absorber Overview ] Wheel Bearing Housing, Wheel Bearing Unit and Coil Spring Shock Absorber Overview