Rear Headrest

Rear Headrest

Removing






Follow the safety precautions for the rollover protection. Refer to => [ Rollover Protection Safety Precautions ] Rollover Protection Safety Precautions.

- Open the convertible top until the displayed position of the top and the convertible top compartment cover is reached.

- Support the convertible top with a suitable wood stick.

- Disconnect the Ground (GND) cable on the battery.

- Remove the screws - 2 - and remove the head restraint - 1 - and bracket.






Installing

Follow the safety precautions for the rollover protection. Refer to => [ Rollover Protection Safety Precautions ] Rollover Protection Safety Precautions.

Installation is reverse of removal, but note the following:

Make sure no one is standing near the rollover protection when reconnecting the battery. Stand at least 1 meter away.

- Connect the GND cable on the battery.

- ALWAYS perform an output diagnostic test under "Guided Functions" after repairing the rollover protection and only after all work procedures are completed (also if a new rollover protection was installed). Refer to Vehicle diagnostic tester.

For the correct tightening specifications, refer to => [ Rear Head Restraints Assembly Overview ] Rear Head Restraints Assembly Overview.