Operation CHARM: Car repair manuals for everyone.
Home >> Audi >> 2012 >> A5 Cabriolet (8F7) L4-2.0L Turbo (CAEB) >> Repair and Diagnosis >> Body and Frame >> Seats >> Service and Repair >> Overhaul >> Removal and Installation >> Manual Sport Front Seats With Seat Depth Adjustment >> Seat Angle Adjuster

Seat Angle Adjuster







Seat Angle Adjuster

Removing

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components ] Description and Operation.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Remove the front seat. Refer to => [ Manual Standard Front Seat ] Manual Standard Front Seat.

- Attach the front seat to the fixture for seat repair (VAS 6136). Refer to => [ Installing the Front Seat on VAS 6136 ] Installing the Front Seat On VAS 6136.

- Remove tunnel side trim panel. Refer to => [ Sill Side Trim ] Sill Side Trim.

- Remove the seat angle adjustment handle. Refer to => [ Seat Angle Adjustment Handle ] Seat Angle Adjustment Handle.

- Remove the shoulder pin - 2 -.






- Remove the bolt - 3 -.

- Remove the seat angle adjuster - 1 -.

Installing

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components ] Description and Operation.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

Installation is reverse of removal, but note the following:

- Always clean the threaded holes for the self-locking bolts, for example, using a thread tap.

- Replace the shoulder pin - 2 - and the bolt - 3 -.

• Make sure the connectors are installed all the way in and are secure.

Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Connect the battery Ground (GND) cable with the ignition turned on.

• If the airbag indicator lamp (K75) indicates a fault after installation, the Diagnostic Trouble Code (DTC) memory must be checked, deleted and checked again. Refer to the vehicle diagnostic tester.

For the correct tightening specifications, refer to => [ Seat Angle Adjuster Assembly Overview ] Seat Angle Adjuster Assembly Overview.

pro multis · About Operation CHARM