Headlamp Housing

Headlamp Housing

Observe the notes on contact corrosion. Refer to => [ Contact Corrosion ] Service Precautions.

• Headlamps must be adjusted after performing measures that could influence the headlamp adjustment. Refer to => [ Halogen Headlamp, Adjusting ] Halogen Headlamp, Adjusting.

Removing






- Switch off the ignition and remove the ignition key.

- Turn the light switch to the "0" position.

- Remove the lock carrier cover.

- Disconnect the electrical connector - 4 -.

- Remove the screws - 2 and 5 -.

- Loosen the lower bolt - 3 - on the headlamp housing using a long wrench.

• Ignore items - 6 and 7 -.

- Remove the headlamp - 1 - toward the front from the body.

Installing






• Tightening specification, refer to => [ Halogen Headlamp Overview, through MY 2011 ] Halogen Headlamp Overview, Through MY 2011.

Install in reverse order of removal, observing the following:

- When install the headlamp - 2 - in the mount - 1 -, make sure the guide tracks on the headlamp engage into the guides on the mount - arrows -.

• Headlamp must slide gently into the mount and without using force.

- When sliding the headlamp - 4 - in, make sure the headlamp ventilation - 3 - slides evenly into the mount - 2 - for the ventilation hose - 1 - - arrow -.






- Tighten the screws - 2, 3 and 5 -.






- Install the lock carrier cover.